The DTS3250/16Tx module requires 28 Vdc @ 9 VA. If an optional heater is installed, the power consumption may be as high as 70 VA while the heater is operating.

The DTS3250/32Tx module requires 28 Vdc @ 14 VA. If an optional heater is installed, ,the power consumption may be as high as 140 VA while the heater is operating.

The DTS3250/64Tx module requires 28 Vdc @ 27 VA. The heater option is not available for this model.

The IP Address in a DTS3250 series module may be changed by a user. The IP address is stored as a variable in the operating system. This variable can be changed only by using the RS232 connection. A procedure for this may be found in the DTS3250 Manual.

Verify that the Ethernet cable is the correct cable for the connection. A "straight wired" cable must be used if the Host computer is connected to the DTS module through a hub. For direct connections from a Host to a DTS module, a "cross wired" cable must be used.

The Host computer must have an IP address specified to be in the same class as the DTS module. That is, if the DTS module has an IP address of 191.30.5.100, the Host computer must have an IP address of 191.30.x.y.

Software upgrades are available from Scanivalve Corp. A detailed procedure may be found in the DTS3250 Manual, which is also available for download from this website. For more information on updating software for these modules, contact Scanivalve Corp, Product Service Department.

All DTS3250 modules should be re-calibrated at a six month interval for the best accuracy. Scanivalve Corp provides a utility program for customers who can perform their own calibrations. This program is called TempCal and may be downloaded from this website at no charge.