|
Frequently
Asked Questions
Scanivalve
Digital Interface Units
Q:
The SDIU will not accept commands from a Host
computer. Answer
Q:
The SDIU loses the setup when
powered down. Answer
Q:
The display is flickering. Answer
The
SDIU will not accept commands from a Host computer.
The End of Transmission characters stored in memory
do not match the characters used by the Host Computer.
Read
FAQs on Scanivalve Digital Interface Units
View
all FAQ topics
The
SDIU loses the setup when powered down.
The battery in the Non-volatile RAM chip has failed.
The chip(Dallas DS1220) must be replaced.
Read
FAQs on Scanivalve Digital Interface Units
View
all FAQ topics
The
display is flickering.
The power supply voltage(s) is(are) too low.
Read
FAQs on Scanivalve Digital Interface Units
View all FAQ topics
|
