|
Pressure
Measurement Products
Data
Systems - Ethernet/ARINC
The
data systems below are designed for use with Scanivalve’s
ZOC miniature pressure scanners or electrical input
modules. They accept up to 8 each 64 channel ZOC miniature
pressure scanners or electrical input modules. These
compact pressure measuring systems communicate by Ethernet
TCP/IP, Serial, or ARINC 429. Pressure data are output
in Engineering Units. Scanivalve Software Development Kit for LabVIEW 2009 (for ver 8.2 & up) is available.
-
625 Hz/channel/second sampling speeds
-
Vacuum, 10 inch H20 up to 850 psi pressure range
-
Auto zero offset correction
Products
and Accessories:
E-RAD4000 Remote A/D
Pressure Input Channels: 1 up to 8 A/D’s per RADBASE4000.
Application: Lab, wind tunnel, wind engineering
Communication: Ethernet TCP/IP
Click
for more details (PDF 2.47MB)
|
|
Products
and accessories
E-RAD Accessories
RDS3200
Remote Digital Switch
Plug-in module for the RAD4000 data system.
RDS incorporates 8 software controlled switches
that can open or close relays
Click for more details (PDF
122KB)
|
|
RPM1000
Power Supply
Power supply for RADBASE4000. Power cable is ordered
separately.
Click
for more details (PDF
31KB) |
|
MSCP3200
Miniature Solenoid Control Pack
Miniature solenoid valves designed to be used inside
a wind tunnel model or other compact space.
Click for more details (PDF
59KB) |
|
Products
and accessories
Additional
Pressure Measurement Data Systems
DSM3400
Digital Service Module
Pressure Input Channels:
Maximum of 512
Application:
Flight test, lab, wind tunnel
Communication:
Ethernet TCP/IP or ARINC429
Click
for more details (PDF 930 KB)
|
|
DSAENCL4000
19 inch Rack Mounted Pressure Measurement
System
The DSA3016 16 channel pressure module fits into
this Intelligent 19 inch enclosure. The enclosure
provides power, EU conversion, and Ethernet interface.
Pressure Input Channels:
16 up to 128
Pressure Range: Vacuum,
10 inch H20 up to 850 psid
Pressure Inputs:
1/8 inch Brass Swagelok® fittings-front access,
1/16 inch rear access
Fluids:
Gas measurement only
Click
for more details (PDF
512KB)
|

Rear
access shown
|
SPC4000 Scanivalve Pressure Calibrator
Scanivalve’s pressure calibrator accurately regulates and measures pressures for pressure sensor characterization. When used with the Scanivalve DSA or ZOC pressure modules, it can provide automated on-line pressure calibration.
Pressure Range: 0.36 psi up to 850 psi.
Communication: Ethernet
Click
for more details (PDF
2MB)
|
|
Products
and accessories |