DSAENCL4000 rack mounted pressure scanner is now available with Digital Signal processing (DSP). This pressure data system has a real time operating system with low data latency. New features include both Ethernet 100baseT and RS-232 interfaces as well as pressure measurement from inches H20 to 850 psi. See details (PDF 512KB).
DSA3307 is a wet/wet differential pressure scanner. Because both sides of the sensors are isolated by a steel diaphragm, different fluids can be measured on one DSA3307 scanner. It is available from 2 to 16 differential measurements in any combination of pressure ranges from 1 psid to 300 psid. See details (PDF 502KB).
E-RAD4000 is a compact Intelligent pressure measurement system. It converts analog pressures from our ZOC pressure scanners to Engineering units and then transmits them up to 625 samples/channel/sec via Ethernet 100baseT. It has a real time processor using Digital Signal Processing (DSP). See details (PDF 2.53MB).
SPC4000 Scanivalve pressure calibrator provides automated calibration of Scanivalve’s DSA and ZOC pressure scanners. The calibrator is available with up to 4 pressure ranges, with .01% F.S. accuracy. Available ranges are 0.36 psi up to 850 psi. See details (PDF 1.83MB).
LabVIEW®
Scanivalve has developed a Configuration Utility which includes the LabVIEW 2009 runtime engine. This one utility works with all Scanivalve Ethernet products. For those users who want to customize the driver, Scanivalve has developed a Software Development Kit for LabVIEW 2009 (for ver 8.2 and up)
LabVIEW is a registered trademark of National Instruments.
Scanivalve
Corporation
1722 N. Madson Street, Liberty Lake
Washington 99019, USA
E-Mail: scanco@scanivalve.com
US Office Toll-free: 800-935-5151
US Office: +1 509-891-9970